![arduino 1.8.5 flashed to davinci 1.0a arduino 1.8.5 flashed to davinci 1.0a](http://www.56chevy.com/pics/b1110.jpg)
#Arduino 1.8.5 flashed to davinci 1.0a how to
Then I also realized the X Axis was shifted!, so I found a video on YouTube from XYZ on how to fix it and I did that too. On the other hand, I took the side panels apart yesterday and under close inspection I realized my X belt tensioner was cracked, so I printed a new one and it improved a little the circles. ONe additional question regarding that, my screen says 0.92.10.M and not "BETA" like luc-github, where is my 0.92.10M coming from? is it the same as luc-github? Do you know if anybody uses that with DaVinci? should I go that way instead? (Now that IM refreshing it might be a good idea to get the latest, maybe I can wrote to luc-github and ask if he has that version for DaVInci) I noticed there is a 1.0.3 version of Repetier firmware, but luc-github doesnt have it pre0configured. Yesterday I came across luc-github Repetier for DaVinci, the latest he has is 0.92.10 Beta, I didnt know if luc-github is somehow 'official' or 'expected to work' so I didnt move forward but now that you tell me I will use that. I found that a backup of eeprom can be done on Host for Windows (didnt realize before because my primary machine is Mac and I dont think there is an Export option there). Is there such a think as this offset im talking about? do I have to do it on the firmware and loaded on the DaVinci again using Arduino IDE? (my printer came with Repetier so I dont know if reflashing is possible)
![arduino 1.8.5 flashed to davinci 1.0a arduino 1.8.5 flashed to davinci 1.0a](https://i.ytimg.com/vi/TzNZ4XhiYj4/maxresdefault.jpg)
Not sure what else to check or how to adjust an offset on Repetier that could correct this. I checked that all belts and rods have tension and are straight and the motor screws are tight. I tried with other models, circles are the same, always skew. I have printed it on ABS and PLA, same thing, in multiple colors and multiple settings. My eyes also say the actual boat is skew a little but hard to notice, thats why I focused on the circle. I have another friend who has a Davinci 1.0 that seem to have the same problem.
#Arduino 1.8.5 flashed to davinci 1.0a full
The full boat is here below, and the circle can be seen at the top. I already downgraded back to 3.0.2 and am up and working again. The circle below is the 3DBenchy_-_Multi-part_-_Single_-_Chimney_top_-_ from the 3DBenchy boat at thingiverse. I think my shapes are not printing right, but it is most noticeable with horizontal circles. Ive been using it with Repetier host on my Mac, and also printing from the onboard SD card. I got a used DaVinci 1.0a with Repetier 0.98 already installed on it.